Innotech Genesis II Digital Controller (v5) - Manual (Page 63)

Page 63
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010 Chapter 3 – Electrical Installation
END OF
CABLE
JUMPER
RS485
COMMS
CONNECTIONS
POWER
3-4.13 GENII CSFCAH REM Control Station Fan Control A/H Module
The GENII CSFCAH REM Control Station Fan Control, A/H Module is powered by 24VAC ±10% @ 50/60
Hz. Power Consumption is 3VA maximum.
The GENII CSFCAH REM mounts into a standard electrical wall plate. The only connections to the
GENII CSFCAH REM are 24VAC power and the RS485 Comms link. Locations of electrical terminals are
shown in Figure 3-17, which is a rear view of the module.
When all connections have been made, protect the module from dirt and moisture by covering it with
plastic but do not mount the module in the wall plate until commissioning is completed. This is to
allow addresses to be set as part of the commissioning process.
Figure 3-17: GENII CSFCAH REM Control Station Fan Control, A/H Module