Quantum TC2201 - Manual (Page 72)

Chapter 2 TC2201 Web Interface
Utilities Page
Quantum TC2201 User’s Guide 52
Figure 40 SCSI Command
Tracking Page
• SCSI Command Tracking can be toggled to ON or OFF. When
toggled ON and Submitted, all SCSI commands received or
transmitted to or from the TC2201 are then logged in the SCSI
Commands section shown on this screen. When set to OFF (and
Submitted), no SCSI commands are logged.
• Previous entries for SCSI Command Tracking can also be cleared.
Toggling the clear option to the ON position and selecting the
Submit button will clear all previous entries.
The settings for the Host/Device ID Table are used to filter the trace data
such that a sub-set of the total logged information is displayed under the
SCSI Commands section. Logged data can be defined according to the
Protocol (FC, Other, or ALL), Type (Device, Host, or ALL), and Value (ID
or ALL). For the ID, this can be a specific FC LUN or Switch ID (S_ID) or
some other specific value. Selecting the Submit button activates the
settings for Protocol, Type, and Value.