Quantum TC2201 - Manual (Page 146)

Get a Copy of Trace Buffer or Event Log
Quantum TC2201 User’s Guide 126
Get a Copy of Trace Buffer or Event Log
4
Using the following procedure, you can save copies of the trace buffers or
the event logo over FTP.
1 Connect the TC2201 to the ethernet network used by your computer.
2
Start your FTP program using the TC2201’s IP address:
ftp <IP address>
The default IP address is 1.1.1.1.
3
Enter the user name and password. The default values for user name
and password are
root
for the user name and
password
for the
password.
4
Specify Bin mode:
bin
5 Specify the filename (.txt file) with the
get
command.
For the current trace buffer, use
get curtrace.txt
.
For the previous trace buffer, use
get prvtrace.txt
.
For the assert trace buffer, use
get assertlog.txt
.
For the current event log, use
get eventlog.txt
.
The file will transfer to the current directory specified on your computer’s
FTP utility. If running FTP from a DOS or Linux command line, the
destination directory can be set using the lcd command (ex.
lcd c:\myCfg
).
Note: You may also need to specify the directory location on your
computer or network where your FTP program will store the
trace file.
Note: If the TC2201 is to use a static IP address, the default IP
address 1.1.1.1 should be changed to an address that is
appropriate for the IP network it will reside on. Note that the
default IP address can be used in a direct connection between
the TC2201 and the host computer via a crossover Ethernet
cable.