Quantum TC2201 User Manual

Page 145

Backup/Restore Configuration Settings

Quantum TC2201 User’s Guide

125

ftp <IP address>
The default IP address is 1.1.1.1.

Enter the user name and password. The default values for user name

and password are root for the user name and password for the

password.

Specify binary mode:
bin

Specify the configuration’s path and filename (.cfg file) with the put

command:
put <path:filename.cfg>

The file will transfer and the TC2201 will reboot. The TC2201 will then be

using the configuration.

Note:

If the TC2201 is to use a static IP address, the default IP

address 1.1.1.1 should be changed to an address that is

appropriate for the IP network it will reside on. Note that the

default IP address can be used in a direct connection between

the TC2201 and the host computer via a crossover Ethernet

cable.

Note:

World Wide Name (WWN) values and Ethernet physical

address (MAC address) values will revert to the factory

default settings. Any user defined values for these settings are

not retained and must be re-entered after a configuration is

restored. See the Configuration Backup Procedure earlier in

this chapter for more information.

Note:

You should confirm the new configuration by checking that

the settings are correct.