Quantum TC2201 - Manual (Page 111)

Perform Configuration
Quantum TC2201 User’s Guide 91
0 and iSCSI Port 1. For additional details on iSCSI Portal Group
settings, see the iSCSI Portal Group Configuration Menu as described
earlier in this Chapter.
• Select 1 from the ‘Device Mapping Main Menu’ to display all the
maps defined by the system for the current protocol/port and to
choose one of the maps from the list to make it a “current” map. The
map selected from this list will be the one used by the TC2201 to
direct data to the appropriate targets and initiators.
Table 23 Select
Current Map
Enter the number from the column on the left side of the table to select a
map and make it ‘Current’. For example, entering ‘2’ from the picture
above would select map named ‘Auto Assigned’ on iSCSI Port 0 and
make it a ‘Current’ map.
Select Current Map
X.XX.XXXX XXXXXX XXXXXXXXXXXXXX
07/26/2005 08:56:22
Current Map for iSCSI Port - ‘Indexed’
+-------+------------+------+--------------------------------+
| MAP # | Protocol | Port | Map Name |
+-------+------------+------+--------------------------------+
| 1 | iSCSI | 0 | Indexed |
| 2 | iSCSI | 0 | Auto Assigned |
+-------+------------+------+--------------------------------+
Page # 1 out of 1 pages.
Total Number of Maps = 2
Enter(N=Next, P=Prev, Number=Select, X=Exit) >
Note:
Because the entire list of Maps may not fit on one screen, select
‘N’ or ‘P’ to go back and forth between screens displaying
more maps. Select ‘X’ to return to the ‘Device Mapping Main
Menu’.