HP 310X - Manual (Page 95)

this IP administrative password.
IP host access list
Specifies up to 10 host systems, or networks of host
systems, that are allowed access to the print server and
the attached networked printing device. ❍
Access is generally limited to host systems specified in
the list. However, if the list is empty, then all hosts are
allowed access. Also, host systems that use HTTP (via
the
embedded web server or IPP ) are not checked against
entries in the access list and are allowed access.
❍
Configured on the print server using the embedded web
server (
Security, Access Control
menu item ), TFTP ,
Telnet , SNMP , or management software.
❍
●
SNMP v1/v2c — Set Community Name
Acts as a password on the print server to allow incoming
SNMP Set commands (from management software, for
example) to write (set) configuration parameters on the
print server.
❍
Authentication of SNMP Set commands will require that
they contain the user-assigned name. ❍
Authentication of SNMP Set commands are further
restricted to systems identified on the
host access list .
❍
Configured on the print server using the embedded web
server ( Network Settings, SNMP menu item ), TFTP ,
Telnet , the IP administrative password (with the optional
synchronization), an SNMP application, or management
application services.
❍
●
Telnet
Telnet is enabled by default, to allow configuration
changes to the print server using the
Telnet tool . You
should disable Telnet access if relying on password
protection.
❍
Configured on the print server using the embedded web
server (
Network Settings, Other Settings, Misc.
❍
●