Menu – HP 310X User Manual
Page 53
of this section.
is the setting you are assigning to that parameter. Allowed values are
described in the second column of the
Telnet commands and parameters
list at the end of
this section.
At any time during a Telnet session, you can enter one of the following:
?
to view available configuration parameters, the correct command format, and a list of commands.
advanced
?
to list additional “advanced” commands.
/
to display the current configuration.
Caution: Parameter changes are not saved until step
below.
Repeat the previous step to set any additional configuration parameters.
2.
When you have finished entering the configuration parameters, at the Telnet prompt enter one of the following
commands, which depend on your system.
save
exit
quit
3.
When prompted whether to save settings that you have changed, enter
y
for “yes”, or
n
for “no”.
4.
Menu interface procedure
Use the following procedure for Telnet’s menu interface to change parameters. The menu interface eliminates the need to
memorize commands, and provides structured menu lists for easy access to configuration parameters.
At the Telnet prompt “
>
” enter:
menu
The
below illustrates the menu interface, using the TCP/IP menus as an example.
1.
From the Main Menu, select and enter a menu number. If there are submenus, select and enter a submenu number.
2.
If you want to change a parameter setting, enter
y
(for “yes”) when prompted.
Changes to parameters are made by editing the setting through the use of the
[Backspace]
key. If an
unrecognized value is entered, the correct entry options will be displayed. The values allowed for each parameter are
3.