HP 310X - Manual (Page 115)

General Jetdirect Information
Provides general print server status and identification information.
Message Description
Status Current state of the print server.
I/O Card Ready the print server has successfully connected
to the network and is awaiting data.
●
I/O Card Initializing the print server is initializing the
network protocols. For more information, see the status line for
each protocol on the configuration page.
●
I/O Card Not Ready there is a problem with the print
server or its configuration.
●
An error code and message are displayed if the print server is not ready.
Model Number The model number of the HP print server (for example, J6035A or
J6038A ).
Hardware
Address The 12-digit hexadecimal LAN hardware (MAC) address of the print
server installed in or attached to the printing device. This address is
assigned by the manufacturer.
Firmware
Version The firmware revision number of the print server currently installed in
the printer. The format is
X.NN.NN , where X is a letter that depends
on the HP print server model.
Port Config Identifies the link configuration of the RJ-45 LAN port on the print
server:
10BASE-T HALF 10 Mbps, half-duplex ●
10BASE-T FULL 10 Mbps, full-duplex ●
100TX HALF 100 Mbps, half-duplex ●
100TX FULL 100 Mbps, full-duplex ●
Unknown the print server is in an initialization state. ●
Disconnected a network connection has not been detected.
Check network cables.
●
Auto
Negotiation Identifies whether IEEE 802.3u Autonegotiation on the 10/100TX port is
enabled (
on ) or disabled ( off ).
On the print server will attempt to automatically configure itself onto the
network at the proper speed (10 or 100 Mbps) and mode (half or full
duplex).
Manufacturing
ID The manufacturing identification code for use by HP support personnel.
Date
Manufactured Identifies the date of manufacture of the HP Jetdirect print server.