HP 310X - Manual (Page 41)

TFTP Parameter Description
appletalk:
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server:
0 Disables.
1 (default) Enables.
DLC/LLC parameters for TFTP [not for 175x]
TFTP Parameter Description
[not for 175x]
dlc/llc:
Enables or disables DLC/LLC protocol operation on the print server:
0 Disables.
1 (default) Enables.
Other parameters for TFTP
TFTP Parameter Description
scan-config:
Enables or disables the web scanning feature in the embedded web server, when
connected to a supported device:
0 Disables.
1 (default) Enables.
scan-idle-timeout:
Specifies the number of seconds (1–3600) that an idle scan connection is allowed to
remain open. 0 disables the timeout. The default is 300 seconds.
scan-email-config:
Enables or disables the scan-to-email feature in the embedded web server, when
connected to a supported device:
0 Disables.
1 (default) Enables.
MFP-config:
Enables or disables print server support of the client software provided with your
multifunction peripheral (MFP) or All-In-One:
0 (default) Disables (allows printing only).
1 Enables (allows printing, scanning, etc.).
usb-mode: Specifies the communication mode over the USB port on the print server:
Auto (default) Automatically negotiates and sets the the highest
communication mode possible for the attached printer or device.
MLC (Multiple Logical Channels) An HP-proprietary communication mode
that allows multiple channels of simultaneous print, scan, and status
communications.
BIDIR A standard connection that supports bi-directional communications
between the printer and print server. The print server sends print data and
receives status from the printer.
UNIDIR A standard connection in which data is transferred in one
direction only (to the printer).
usb-statpg-lang: Specifies the page description language (PDL) used by the print server to send the
Jetdirect configuration page to the printer:
Auto (default) The language is auto-detected when the print server is
powered on or after a cold reset to factory defaults.
PCL Hewlett-Packard Printer Control Language
ASCII Standard ASCII characters
HPGL2 Hewlett-Packard Graphics Language (v2)
PS Adobe PostScript language
Support parameters for TFTP