Moving the print server to another ip network – HP 310X User Manual

Page 32

(raw IP printing)

TCP port 9100
(HP proprietary)

Moving the print server to another IP network

When moving an HP Jetdirect print server configured with an
IP address to a new network, ensure that the IP address does not
conflict with addresses on the new network.

First, do one of the following:

Change the IP address to one usable on the new network.

❍

Erase the current IP address and configure another
address after you are installed on the new network.

❍

Then reset the print server to factory defaults:

instructions

Finally, do one of the following:

If the print server was configured using BOOTP or
DHCP, edit the appropriate system files with updated
settings. If the current BOOTP server is not reachable,
you may need to locate and configure a different BOOTP
server.

❍

If the IP address and other parameters were manually set,
then manually reconfigure them.

❍

This manual is related to the following products:

175X Jetdirect 310x Print Server for Fast Ethernet