Configuration, Network settings, Tcp/ip settings – HP 310X User Manual
Page 73: Person to contact for this device. see, Tcp/ip
❍
❍
❍
❍
Configuration:
Network Settings
tab
tab
Click on the
Networking
tab at the top of the web page. (Make sure that beneath
Configuration
in the left column of the page,
Network Settings
is selected.) The
Network Settings
pages allow you to set or change configuration parameters for
TCP/IP, IPX/SPX, AppleTalk, and SNMP protocols. To assign a parameter setting,
enter the desired value and click
[Apply]
.
Notes
If you enter or change a configuration parameter value, click
[Apply]
to enable
your change, or click
[Cancel]
to erase your change.
●
Changes to the IP address will close the connection to the embedded web
server. To re-establish a connection, use the new IP address.
●
TCP/IP settings
Click on the
Networking
tab. If the
TCP/IP
tab is not highlighted, then beneath
Configuration
in the left column of the page, select
Network Settings
, and then
select the
TCP/IP
tab in the second row of tabs across the page. To assign a
parameter setting, enter the desired value and click
[Apply]
.
TCP/IP Settings