HP 310X - Manual (Page 60)

write-mode
Controls the setting of the TCP PSH flag for device-to-client data transfers:
0 (default) Disables this option, flag not set.
1 All-push option. Push bit is set in all data packets.
2 EOI-push option. Push bit is set only for data packets that have an End-of-Information flag
set.
mult-tcp-conn
Enables or disables multiple TCP connections:
0 (default) Allows multiple connections.
1 Disables multiple connections.
TCP/IP raw print port parameters for Telnet
Telnet Parameter Description and Values
raw-port
Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to 9000, which
are application dependent.
TCP/IP access control parameters for Telnet
Telnet Parameter Description and Values
allow Makes an entry into the host access list stored on the print server. Each entry specifies a host or
network of hosts that are allowed to connect to the printer. The format is:
allow netnum [mask] where:
netnum is a network number or host IP address.
mask (optional) is an address mask of bits applied to the network number and host address
to verify access.
Up to 10 access list entries are allowed. If there are no entries, all hosts are permitted access.
For example:
allow 192.0.0.0 255.0.0.0 Allows hosts on network 192.
allow 192.168.1.2 Allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow 0 Clears the host access list.
For additional information, see security .
TCP/IP other parameters for Telnet
Telnet Parameter Description and Values