HP 310X User Manual
Page 131
53
BAD BOOTP TAG
SIZE
The tagsize in a vendor specific field in the BOOTP reply is either 0, or
greater than the remaining number of unprocessed bytes in the vendor
specified area.
54
BOOTP/RARP IN
PROGRESS
The print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
55
BOOTP/DHCP IN
PROGRESS
The print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected
any errors.
56
DHCP NAK
The print server received a negative acknowledgment message from the
DHCP server in response to a configuration request.
57
UNABLE TO
CONNECT DHCP
SVR
The print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the
DHCP server.
If an infinite lease was assigned, the print server will use the IP address
of the most recent DHCP server used, but operation may be degraded
until a DHCP server responds.
58
POSTSCRIPT
MODE NOT
SELECTED
The printer does not support AppleTalk or AppleTalk extensions.
59
INCOMPLETE
F/W- MUST
DOWNLOAD
Firmware download message. Currently downloading firmware to the
print server, or the download did not complete properly.
5A
TURN PRINTER
OFF/ON
Firmware download message. Download of firmware is complete.
Power cycle the print server.
83
DISCONNECTING
FROM SERVER
The server has been shut down because of a configuration change or
reset request. This message automatically clears after a few seconds,
unless the printer is off line, is in an error state, or is servicing another
I/O port or another network protocol.
End of troubleshooting
If you have not been able to correct your print server problem using this troubleshooting
procedure, you will need to contact HP technical support for further assistance. Click on the button
below for details.
©2000, 2001 Hewlett-Packard Company