Tcp/ip configuration, Tcp/ip, Introduction – HP 310X User Manual
Page 24
TCP/IP Configuration
for HP Jetdirect 175x external print server/Internet connector for USB
and HP Jetdirect 310x external print server/Internet connector for
USB
Summary of TCP/IP Configuration
●
Overview of the TCP/IP Protocol
●
Using BOOTP and TFTP
●
Using DHCP
●
●
Using the arp and ping commands
●
●
●
Using a syslog server
●
Moving the networked printer to another network
●
Ports for IP access to the HP Jetdirect print server
●
Introduction
To operate properly on a TCP/IP network, the HP Jetdirect print
server must be configured with valid TCP/IP network configuration
parameters, such as an IP address. Depending on your printer and
system, this can be done in the following ways:
Note: When shipped from the factory, the HP Jetdirect
print server has no IP address. If the HP Jetdirect print
server is not configured with a valid IP address within
two minutes after power up, a factory default value of
192.0.0.192 will be automatically assigned. This address
must be reconfigured with a valid address for use on your
TCP/IP network. For more information on TCP/IP
networks, see
TCP/IP overview
.
By using your printer installation software or the HP Jetdirect
print server installation software on supported systems. For
more information see the
.
●
By downloading the data from a network-based server using
BOOTP (Bootstrap Protocol) and TFTP (Trivial File Transfer
Protocol) each time the printer is turned on. For more
●