HP FAX-700 - Manual (Page 214)

Problem Resolution 5Ć39
Table 5-7. HP FAX-900 and FAX-950 Function Parameters (Continued)
No. Parameter Selections Function
45 RING DET. COUNT
(2) 1 = 1 ring
.
.
9 = 9 rings Selects a ring detect count from 1 to
9 times in one-step intervals
46 ON-HOOK TIME
(5 sec) 0 = 0 sec
.
.
90 = 90 sec Selects on-hook time between se-
quential communication calls from 0
to 90 seconds in 1 second steps
47 RESPONSE WAIT
(65 sec) 1 = 1 sec
.
.
90 = 90 sec Selects waiting time to respond after
finishing the dialing in 1 second steps
48 EXT. TEL DIAL
(Invalid) 1 = Invalid
2 = Valid Selects whether or not key pad dial is
available when the external phone is
off-hook
49 Not Used
50 RING DET. MODE
(Normal) 1 = Normal
2 = Rough Selects seriousness of ringer detec-
tion. If the line signal is “noisy”, set to
Rough so the machine will be more
likely to detect signals
51 TONE DET. MODE
(Normal) 1 = Normal
2 = Rough Selects seriousness of dial tone and
busy tone detection. If the line signal
is “noisy”, set to Rough so the ma-
chine will be more likely to detect sig-
nals
52 PULSE RATE
(10 pps) 1 = 10 pps
2 = 20 pps Selects the dial pulse rate
53-54 Not Used in U.S.
55 BUSY TONE CHECK
(On) 1 = Off
2 = On Selects busy tone detection function
56-57 Not Used in U.S.
58 Not Used
59
(FAX-950
Only)
CONF. RCV REPORT
(On) 1 = Off (not printed out)
2 = On (printed out) Selects whether or not CONF. RCV
REPORT is printed
60 VERSION Indicates the machine type (900 or
950) and the ROM version in the
message window
61 TX/RX/PRT
COUNTER TX/RX/PRINT Indicates the transmitted, received
and printed document count
62-63 Not Used
64 SILENT DET. T. OUT
(60 sec) 00 = 0 sec
.
.
99 = 99 sec Select silent detection timeout time
(TAM I/F)