HP FAX-700 - Manual (Page 210)

Problem Resolution 5Ć35
Function Parameters for the HP FAX-900 and FAX-950
Listing the Function Parameter Settings on the HP FAX-900 and FAX-950 (Test Mode 3)
Use the following procedure to print a list of the function parameter settings. An asterisk (
:) in front of the function
parameter setting means that it has been changed from the factory default setting (U.S. shipment setting).
Note
Function parameters not set to the factory default setting may be a result of the user setting the fax
parameters. Verify the user’s preference for these settings prior to resetting these function
parameters.
Note
Function parameters 080 and 081 are tuned at the factory to optimize the unit’s scanning
operation. Therefore, these settings may differ from the standard function parameters and
resetting the fax machine to the shipment settings does not reset these two settings.
Stop
Menu
→
Dial/Space
7
→
Tone
→
x 4 → L
PRS
Start
→ 3
→
DEF
Test mode 3 prints a list of the function parameter settings. The printout is useful for reviewing the function parameter
settings or producing a hard copy record of the settings. Use the following procedure (verbal description of the dia-
gram above) to print the function parameter settings:
1. With the fax machine in standby mode (message window showing date and time), press Menu. Then press 7.
2. With the message window showing SET MODE NO. =, press Dial/Space four times. The unit sounds an error
beep for each key entry, but this is normal.
3. Press
:.
4. With the message window showing SET MODE NO. =, press 3 to select test mode 3.
5. Press Start to print a listing of the function parameters.
6. Press Stop to return to the Standby mode.
Changing the Function Parameters on the HP FAX-900 and FAX-950 (Test Mode 1)
Stop Start
→
1
→
Parameter
Number Parameter
Value
To Repeat
Menu
→
Dial/Space
7
→
Tone
→ x 4 → L
PRS
Start
→
Start
→ →