HP FAX-700 - Manual (Page 192)

Problem Resolution 5Ć17
Table 5-1. Information Codes on the HP FAX-700 and FAX-750 (Continued)
Info
Code
Mode Description of the Problem Action
577 Rx
ECM
After receiving PPS Q command, received
DCN command while in the subroutine to
receive a command following RNR transĆ
mission
Check for fax completeness. Contact the
sending station. Retry fax reception
578 Rx
ECM
After receiving PPS Q command FCS error
occurred & carrier did not go away for the
T6" time period while in the
commandĆreceive subroutine following
RNR transmission
Check for fax completeness. Contact the
sending station. Retry fax reception
579 Rx
ECM
After receiving the EOR Q command, reĆ
ceived DCN command while in the comĆ
mandĆreceive subroutine following RNR
transmission
Check for fax completeness. Contact the
sending station. Retry fax reception
580 Rx
ECM
After receiving the EOR Q command, FCS
error occurred and the carrier did not go
away for the T6" time period while in the
commandĆreceive subroutine following
RNR transmission
Check for fax completeness. Contact the
sending station. Retry fax reception
581 Rx
ECM
When receiving a message, the next
frame was not received within the stipuĆ
lated time period
Check for fax completeness. Contact the
sending station. Retry fax reception
582 Rx
ECM
Image quality of received message data
was not good
Check for fax completeness. Contact the
sending station. Retry fax reception
591 Tx In the T1" time period after
(NSF)(CSI)DIS/(NSC)(CIG)DTC was sent,
the Stop button was depressed
Contact sending station
592 Rx Stop button was pressed during the reĆ
sponse wait state ...
After (PRI)MPS/(PRI)EOM/(PRI)EOP
was sent.
After DCS/TCF was sent.
After PPS NULL/PPS (PRI)MPS/PPS
(PRI)EOM/PPS (PRI)EOP was sent.
After EOR NULL/EOR (PRI)MPS/EOR
(PRI)EOM/EOR (PRI)EOP was sent.
After RR response or CTC response
Resend document
593 Tx Stop button was pressed during the transĆ
mission of a document
Resend document
594 Rx Stop button was pressed during T1" time
period at the reception of DIS/DTC signal
Contact sending station
595 Rx Stop button was pressed during T2" time
wait state during fax reception
Contact sending station
596 Agency
Comp.
Stop button was pressed while executing
the Agency Compliance Mode
Not applicable
601 Tx Misfeed of transmission document Remove document and resend