HP FAX-700 - Manual (Page 194)

Problem Resolution 5Ć19
Service Parameters for the HP FAX-700 and FAX-750
Service parameters are internal settings and default modes that determine how the fax machine operates and responds.
Some service parameters select signal levels, signal timing, and default modes of operation. Others display status
information (such as document count) or enter test modes. A complete listing of the service parameters for the HP
FAX-700 and FAX-750 is given in Table 5-2.
Note
Service parameters are initially set at the factory and most parameters will not require any
change.
Listing the Service Parameter Settings on the HP FAX-700 and FAX-750
Note
Service parameters not set to the standard setting may be a result of the user setting the
parameters. Verify the user’s preference for these settings before resetting these parameters.
To print a list of the service parameter settings, press the buttons and follow the procedure below:
7
→
Menu
→
Press & hold
down the
Stop button
→ 0
→
0
→
Release the Stop
and Menu buttons →
The following message appears:
Service Menu (01 – 12)
12: Service P. Report
Press the Enter button. The fax machine will print a list of the service parameter settings. It lists the current and stan-
dard settings.
While the machine is printing a list of the parameters, the following message is on the front panel LCD.
Printing service
parameter list
To exit the service menus and return the fax machine to the standby state, press the Stop button.
The printout is useful for reviewing the service parameter settings or producing a hard copy record of the settings. Use
the following procedure to print the service parameter settings: