General network settings, Subnet mask, see – HP 2570 User Manual
Page 40
Network configuration page definitions
The configuration page shows the network settings for the HP All-in-One. There are
settings for general information, 802.3 wired (Ethernet), and Bluetooth
®
.
For information on how to print a network configuration page, see
. For additional information on terms used here, see the Network
Glossary in the onscreen
HP Image Zone Help
that came with your HP All-in-One.
For information on using the onscreen
HP Image Zone Help
General network settings
The following table describes the general network settings shown on the network
configuration page.
Parameter
Description
Network Status
Status of the HP All-in-One:
●
Ready: The HP All-in-One is ready to receive or transmit data.
●
Offline: The HP All-in-One is not currently connected to the
network.
Active
connection type
Network mode of the HP All-in-One:
●
Wired: The HP All-in-One is connected by Ethernet cable to
an IEEE 802.3 network.
●
None: There is no network connection.
URL
The IP address of the Embedded Web Server.
Note
You will need to know this URL when you try to access the
Embedded Web Server.
Firmware
Revision
The internal networking component and device firmware revision
code.
Note
If you call HP Support, depending on the problem, you
might be asked to provide the firmware revision code.
Hostname
The TCP/IP name assigned by the installation software to the
device. By default, this is the letters HP followed by the last 6
digits of the Media Access Control (MAC) address.
Admin
Password
Status of the administrator's password for the Embedded Web
Server:
●
Set: Password is specified. You must enter the password to
make changes to the Embedded Web Server parameters.
●
Not Set: No password is set. A password is not required for
making changes to the Embedded Web Server parameters.
mDNS
Rendezvous is used with local and ad hoc networks that don't use
central DNS servers. To perform name services, Rendezvous
uses a DNS alternative called mDNS.
User Guide
37
Network setup