HP 2830 - Manual (Page 96)

Using manual dial
Usually, the device dials after you press S
TART
F
AX
. At times, however, you might want the
device to dial each number as you press it. For example, if you are charging your fax call to
a calling card, you might need to dial the fax number, wait for the acceptance tone of your
telephone company, and then dial the calling card number. When dialing internationally, you
might need to dial part of the number and then listen for dial tones before continuing to dial.
To use manual dial with the automatic document feeder (ADF)
1. Load the document into the automatic document feeder (ADF) input tray or onto the
flatbed scanner.
2. On the device control panel, press S
TART
F
AX
.
3. Begin dialing. The device dials the number as you press each digit. This allows you to
wait for pauses, dial tones, international access tones, or calling card acceptance tones
before continuing to dial.
To use manual dial with the flatbed scanner
1. On the device control panel, press S
TART
F
AX
. The control-panel display shows the
following message: Send from glass? 1=Yes 2=No.
2. Press 1 to select YES. The control-panel display shows the following message: Load
page:X Press [enter], where X is the page number.
3. Scan a page into memory by placing the sheet print-side-down on the flatbed scanner
and pressing E
NTER
. After scanning the page, the device control-panel display shows the
following message: Another page? 1=Yes 2=No.
4. Complete one of the following steps:
If you have more pages to scan, press 1 to select YES, and then repeat step 3 for each
page of the fax job.
If you are finished, press 2 to select NO, and then go to the next step.
5. When finished scanning all pages into memory, begin dialing. The device dials the
number as you press each digit. This allows you to wait for pauses, dial tones,
international access tones, or calling card acceptance tones before continuing to dial.
80 Chapter 8 Fax ENWW