Troubleshooting process, Troubleshooting checklist – HP 2830 User Manual
Page 229
Troubleshooting process
Use the troubleshooting checklist to solve issues with the device.
Troubleshooting checklist
Follow the steps below when trying to solve a problem with the device.
Step
number
Verification step
Possible problems
Solutions
1
Is the power on?
When the device is
connected to a grounded
power source, the control
panel shows Hewlett
Packard with moving
cursors indicating that the
firmware code is loading,
and the print engine motor
rotates for approximately
45 to 60 seconds. When
the firmware is done
loading, Scanner bulb
warming up appears in
the control panel, and the
scan head moves back
and forth for 10-15
seconds. If you lift the
scanner lid, you will see
that the scanner bulb is lit.
Near the end of this time,
the automatic document
feeder (ADF) motor turns
on for about two seconds.
No power due to failed power source,
cable, switch, or fuse.
1.
Verify that the device is plugged in.
2.
Verify that the power cable is
functional and that the power
switch is on.
3.
Check the power source by
plugging the device directly into
the wall or into a different outlet.
Print engine motor does not rotate.
1.
Verify that the fuser shipping
locks have been removed. For
more information, see the Getting
Started Guide.
2.
Verify that the fuser locks are in
the locked position. See
.
3.
Verify that the print cartridges
and imaging drum are properly
installed. (See
.) Look at the control-
panel messages and follow the
instructions to remove and
replace the cartridges.
4.
Verify that the top cover is closed.
ADF motor does not rotate.
Open the ADF cover and remove any
orange shipping tape inside the ADF.
Verify that the ADF cable is
connected correctly to the scanner.
See
.
If the ADF motor still does not rotate,
replace the ADF. See
automatic document feeder (ADF)
.
Scanner bulb does not light.
If the scanner bulb does not light,
contact HP Customer Care. See
flyer that came in the device box.
ENWW
Troubleshooting process
213