HP 2830 User Manual

Page 50

To change the alarm volume

The alarm sounds when the device is presenting an alert or critical error message. The
alarm duration length is either one or three seconds, depending on the type of error.

1. Press

ENU

2. Use the

or the

button to select System setup, and then press

NTER

3. Use the

or the

button to select Volume settings, and then press

NTER

4. Press

NTER

to select Alarm volume.

5. Use the

or the

button to select Off, Soft, Medium, or Loud.

6. Press

NTER

to save your selection.

Note

The factory-set default for the alarm volume is Soft.

To change the volume for the fax

This setting determines the volume of various fax sounds that occur when the device is
sending or receiving fax jobs.

1. Press

OLUME

2. Use the

or the

button to select Off, Soft, Medium, or Loud.

3. Press

NTER

to save your selection.

Note

The factory-set default is Soft.

To change the ring volume of the fax

The fax ring sounds when the device is initially sending or receiving a call. The ring duration
length depends on the local telecom ring-pattern length.

1. Press

ENU

2. Use the

or the

button to select System setup, and then press

NTER

3. Use the

or the

button to select Volume settings, and then press

NTER

4. Press the

or the

button once to select Ring volume, and then press

NTER

5. Use the

or the

button to select Off, Soft, Medium, or Loud.

6. Press

NTER

to save your selection.

Note

The factory-set default is Soft.

Chapter 4 Using the device

ENWW