HP 2830 - Manual (Page 83)

To reduce or enlarge copies for the current job
To reduce or enlarge copies for the current job only, use the following instructions.
1. On the device control panel, press R
EDUCE
/E
NLARGE
.
2. Select the size to which you would like to reduce or enlarge the copies in this job. You
can select one of the following sizes:
● Original=100%
● Lgl > Ltr=78%
● Lgl > A4=83%
● A4 > Ltr=94%
● Ltr > A4=97%
● Full Page=91%
● Fit to page
● 2 pages/sheet
● 4 pages/sheet
● Custom: 25-400%
If you select Custom: 25-400%, type a percentage by using the alphanumeric buttons.
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or
landscape).
3. Press S
TART
B
LACK
or S
TART
C
OLOR
to save the selection and immediately start the copy
job, or press E
NTER
to save the selection without starting the job.
Note The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control-panel display.
You must change the default media size in the media input tray to match the output size, or
part of your copy might be cut off. For instructions, see
Changing the default media size .
ENWW Reducing or enlarging copies 67