Additional setup, Modifying user accounts and default password – HP RP3440 User Manual
Page 96
2.
Log in using the default the iLO MP user name and password (Admin/Admin). The MP
Main Menu screen displays.
TIP:
For security reasons, HP strongly recommends that you modify the default settings
during the initial login session. See
“Modifying User Accounts and Default Password”
.
Following is the MP Main Menu screen:
MP MAIN MENU:
CO: Console
VFP: Virtual Front Panel
CM: Command Menu
CL: Console Logs
SL: Show Event Logs
HE: Main Menu Help
X: Exit Connection
This example shows the MP Main Menu accessed through the local serial port. The list of
commands displayed on the screen can be different depending on the method of access to the
iLO MP.
When logging in using the local or remote RS-232 serial ports, the login prompt may not display
if another user is logged in through these ports. Use Ctrl-B to access the MP Main Menu and the
iLO MP prompt (MP>).
Additional Setup
This section provides additional information to help you set up the iLO MP.
For complete information on the iLO MP, see the HP Integrity and HP 9000 iLO MP Operations
Guide on the HP website at
Modifying User Accounts and Default Password
The iLO MP comes preconfigured with default factory settings, including a default user account
and password. The two default user accounts at initial login are:
•
All Rights (Administrator) level user:
login = Admin
password = Admin
•
Console Rights (Operator) level user:
login = Oper
password = Oper
NOTE:
User account and password are case sensitive.
IMPORTANT:
For security reasons, HP strongly recommends that you modify the default
settings during the initial login session.
Make the following changes using any of the iLO MP user interfaces.
To modify default account configuration settings, follow these steps:
1.
Log in as the administrator. You must log in as the administrator in order to modify default
user configuration settings.
2.
To modify default passwords, follow these steps:
96
Installing the System