HP RP3440 - Manual (Page 175)

7. Verify the card replacement and operation by using the system utilities. (For additional
information, see
Appendix B (page 199) or the HP Integrity and HP 9000 iLO MP Operations
Guide.)
•
Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
8. Turn on the server.
Removing and Replacing the iLO MP Card Battery
Systems have a second battery that might need replacement. The iLO MP card battery is located
on the underside of the iLO MP card.
Battery Notice
This product contains a Lithium battery (HP part number 1420-0356).
WARNING! Lithium batteries can explode if mistreated. Do not recharge, disassemble, or
dispose of lithium batteries in a fire. Failure to observe this warning can result in personal injury
or damage to equipment.
Replace only with the identical or equivalent battery. Follow the manufacturer’s recommendations.
Dispose of used batteries according to the manufacturer’s instructions.
Removing the iLO MP Card Battery
To remove the iLO MP card battery, follow these steps:
1. Remove the iLO MP card. (See “Removing the iLO MP Card” (page 173) .)
2. Locate the iLO MP card battery on the bottom of the card. (See Figure 6-62 .)
Removing and Replacing the iLO MP Card Battery 175