HP RP3440 - Manual (Page 178)

• Memory (DIMMs). (See “Removing System Memory” (page 152) )
• Dual processor modules. (See “Removing a Dual Processor Module” (page 155) )
• iLO MP card. (See “Removing the iLO MP Card” (page 173) )
4. Remove the mechanical covers that are covering the VGA and DB9 ports.
Figure 6-64 Removing the Mechanical Covers
5. Unscrew the six backplane system board mounting screws that connect the system board
to the rear of the server chassis.
Figure 6-65 Removing the Backplane System Board Mounting Screws
6. Disconnect the AC power cable connectors.
7. Disconnect all cables that are connected to the system board. To help with re-assembly, make
note of which cables were connected to which connector.
8. Lift the fan bridge to access the three power cables near the PCI card cage.
9. Unscrew the system board mounting screw. A screw symbol is adjacent to the mounting
screw.
178 Removing and Replacing Components