HP RP3440 - Manual (Page 128)

Figure 6-4 Removing the Top Cover on a Rack-Mounted Server
3. Lift the top cover off the server chassis.
Replacing the Top Cover on a Rack-Mounted Server
CAUTION: Secure any wires or cables in your server so they will not get cut or interfere with
the replacement of the top cover.
To replace the top cover, follow these steps:
1. Align the front edge of the top cover with the alignment mark on the optical drive bay.
Figure 6-5 Aligning the Top Cover on a Rack-Mounted Server
2. Grasp the blue release lever and slide the cover toward the front of the server until the lever
snaps into place.
128 Removing and Replacing Components