HP RP3440 - Manual (Page 181)

1. Grasp the new system board by its edges and carefully align it in the server:
a.
Angle the board to enable the PCI connector to slide into the PCI card cage bay area.
b. Align the system board keyholes with their standoffs on the chassis.
c. Slide the PCI connector posts on the system board into their slots on the server chassis.
Figure 6-68 Aligning the System Board PCI Connector
2. Slide the system board back toward the rear of the server to secure the system board on its
standoffs.
Figure 6-69 Sliding the System Board in the Chassis
Removing and Replacing the System Board 181