beautypg.com

Environmental specifications, Operating environment, Additional component power consumption – HP RP3440 User Manual

Page 44

background image

Table 2-5 Additional Component Power Consumption

Power Consumption

Additional Component

443.6 Btu/h

130W

Processor

78.4 Btu/h

23W

SCSI hard disk drive (with I/O access)

54.5 Btu/h

16W

SCSI hard disk drive (idle)

34.12 Btu/h to 85.30 Btu/h

10W to 25W

PCI card

Environmental Specifications

This section provides the temperature and humidity requirements, noise emission, and air flow
specifications for the server.

Operating temperature and humidity ranges might vary depending on the installed mass storage
devices. High humidity levels can cause improper disk operation. Low humidity levels can
aggravate static electricity problems and cause excessive wear of the disk surface.

Table 2-6

lists the environmental specifications for a system processing unit with a hard disk

drive.

Table 2-6 Environmental Specifications

Value

Parameter

+5 degrees C to +35 degrees C (+40 degrees F to +95 degrees
F)

Operating temperature

–40 degrees C to +70 degrees C (–40 degrees F to +158
degrees F)

Storage temperature

+40 degrees C (+104 degrees F)

Over-temperature shutdown

15% to 80% relative (noncondensing)

Operating humidity

8% to 85% relative (noncondensing)

Storage humidity

Sound power level

1

Acoustic noise emission (ISO 7779)

Pedestal system

LwA = 5.1 BA

Typical configuration (disk idle)

2

LwA = 5.4 BA

Maximum configuration (disk idle)

3

LwA = 6.2 BA

Maximum configuration (disk active)

3

Rack system

LwA = 6.4 BA

Typical configuration (disk idle)

2

LwA = 6.4 BA

Maximum configuration (disk idle)

3

LwA = 7.2 BA

Maximum configuration (disk active)

3

3048m (10,000 ft.) max

Operating altitude

4600m (15,000 ft.) max

Storage altitude

1

Typical configuration at room temperature (25 degrees C).

2

One processor enabled, one or two SCSI hard disk drives and less than 8 GB of memory.

3

Two dual processors, one or two SCSI hard disk drives and less than 8 GB of memory.

Operating Environment

The system is designed to run continuously and meet reliability goals in an ambient temperature
of 5°C to 35°C (+40°F to +95°F) at sea level. The maximum allowable temperature is de-rated 1°C

44

System Specifications

This manual is related to the following products: