GeoVision GV-AS2120 IP Control Panel User Manual

Page 82

To define ID number, control type and authentication mode

Using the

GV-AS120 Setting AP

in the GV-ASManager folder, you can define the ID

number of multiple GV-AS120 connected through RS-485 interface, as well as set the
control type and authentication mode.

1. Go to

C:\Access Control\ASManager\

and double-click

GV-AS120 SetupAP

V100.exe

. This dialog box appears.

Figure 3-7

2. Select the COM port that is connected to GV-AS120 and click

Open COM

. The red

square should change to blue to indicate the COM port is correct.

Note:

To verify the COM port that is connected to GV-AS120, go to Windows Device

Manager. In the Ports (COM & LPT) field, you should see the entry for

Prolific USB-to-

Serial Comm Port

. The COM port shown in parenthesis indicates the COM number

currently in use.

3. Select an ID number for the GV-AS120.
4. Use the drop-down list to define the

Control Type

and

Authentication Mode

. Refer to

Door / Gate Function

and

Set Authentication Mode

2.3.2 Programming the GV-AS110

for more details on each type of Control Type and Authentication Mode.

5. Click

Setup GO

. The settings are sent to GV-AS120.