GeoVision GV-AS2120 IP Control Panel - Manual (Page 46)

44
1.3.5 Setting Parameters
You can define the parameters of some features on GV-AS100 / 1010.
IMPORTANT:
Once connecting to GV-AS100 / 1010, GV-ASManager will load its
parameters to GV-AS100 / 1010. That means some of the parameters you set up here may
be overwritten by GV-ASManager later.
1. Press the code ＊ 738 ( ＊ SET)
.
2. Present the Master Card and enter its PIN code. The LCD displays
Set Local Time
.
3. Press
0
to change the options. Press
#
to select the option for further programming.
Option Function
Set Local Time Sets the time, time zone and enables daylight saving.
Set AS100 / 1010 ID Sets the ID of GV-A100 / 1010 from 1 to 255.
Set AS1010 IP Sets the IP of GV-AS1010. (GV-AS1010 only)
Set Auth. Mode Sets an authentication mode for the door/gate.
◼ Auth. Schedule:
Follows the authentication schedule set on
GV-ASManager.
◼ Fixed Card Mode:
Grants access after the card is presented.
Ignores the authentication schedule of GV-ASManager.
◼ Fixed Card + PIN:
Grants access after the user presents the
card and then enters the card’s PIN code. Ignores the
authentication schedule of GV-ASManager.
◼ Fixed Card/Common:
Grants access after the user presents
the card or enters the door’s password. Enter the door’s
password after the LCD displays
Common Password
. Ignores
the authentication schedule of GV-ASManager.
◼ Local Unlock Mode:
Remains open. The held-open state
cannot be cleared through GV-ASManager.
◼ Local Lock Mode:
Remains locked. The locked state cannot
be cleared through GV-ASManager.