GeoVision GV-AS2120 IP Control Panel - Manual (Page 70)

68
For example, to enable the Fixed Card + PIN
mode, press
＊ 5264#
.
Open door
with card
number and
PIN code ＊ _ _ _ _ _ _ _ _(_ _ _ _)#
Enter the 8-digit card
number and enter its 4-
digit PIN code.
To open the door without presenting a card, enter
the 8-digit card number on the back of the
individual card and its 4-digit PIN code.
Set ID ＊ 743_ _ _#
Enter an ID number
between 0 and 255.
Set an ID number for GV-AS110 / 1110 to a
number between 0 and 255.
For example, to set the ID number to be 3, press
＊ 743003#
Security Mode ＊ 276_ _ _ _#
4 digits PIN code of the
security card.
In the Security Mode, no cards can be granted
access and no one can program the unit. Only
the Security Card can disable the Security Mode.
To enable the Security Mode, press
＊ 276
, enter
the PIN code of the Security Card and press
#
.
Present the Security Card.
To disable the Security Mode, simply press the
PIN code of the Security Card and present the
Security Card.
Two Person
Entrance ＊ 873_#
Disable ➔ 0
Enable ➔ 1
When Two Person Entrance mode is enabled,
both Two Person A Card and Two Person B Card
must be presented to unlock the entrance.
To enable Two Person Entrance, press
＊ 8731#
Two Person
Exit ＊ 879_#
Disable ➔ 0
Enable ➔ 1
When Two Person Exit mode is enabled, both
Two Person A Card and Two Person B Card
must be presented to unlock the exit.
To enable Two Person Exit, press
＊ 8791#
Select Input
Contact Type ＊ 426_ _ _#
NO ➔ 1
NC ➔ 0
Specify the input contact type of the
door sensor
in the first blank digit,
button
in the second blank
digit and
fire sensor
in the third blank digit. The
default value is normally opened (NO). Note that
the third digit (fire sensor) is not functional for GV-
AS1110, so you can press either 1 or 0.
For example, to set the input contact type for door
sensor to be normally open (NO), button to be
normally closed (NC), and fire sensor to be
normally open (NO), press
＊ 426101#
.
Load Default ＊ 362#
To restore GV-AS110 to factory default, press ＊
362#
. All configured settings will be cleared and
all cards will be deleted from GV-AS110 / 1110.
Note:
The
Parking Entry Type
and
Parking Exit Type
only work when the sensor input of
Car Detection is activated.