GeoVision GV-AS2120 IP Control Panel - Manual (Page 221)

Optional Devices
219
9
9.3.2.G Extended Reader
In the left menu, click
Extend Reader
. This
Extend Reader Configuration
page appears.
Figure 9-28
Define the readers connected to GV-AS100 / 110 / 120, and then use the
Function
drop-
down list to select which door that the GV-Reader/GV-GF Fingerprint Reader is installed.
[GV-Reader Function]
•
GV-RK1352 / R1352 / DFR1352:
Select the checkbox and type the
Serial Number
of
the reader. Note that the ID number located next to the serial number need to match the
reader’s ID number defined through the GV-RK1352 Config AP.
• GV-Reader 1251 / Reader 1352 V2:
Select the checkbox and leave the serial number
field blank. Note that the ID number located next to the serial number need to match the
reader’s ID number defined by the DIP switches on the reader.
•
GV-CR420:
Type the GV-CR420
Barcode
. Only select the checkbox if GV-CR420 is
connected to the controller through RS-485. If the reader is using network connection, do
not check the box. Note that only GV-CR420 V1.0 is compatible with GV-AS100 / 110 /
120 and you must additionally enable network connection to the controller on the Web
interface of GV-CR420.