GeoVision GV-AS2120 IP Control Panel User Manual

Page 180

178

[GV-Reader / CR1320 / GF192x / DES1352 / QR1352 Function]

To connect GV-DES1352

/ GV-QR1352 / GV-R1354, select

QR1352/DES1352

for RS485 Protocol. Otherwise, select

•

GV-DES1352 / QR1352 / R1354:

For the three readers, based on the paired ID number,

select the

RS-485

checkbo

and the corresponding door in the function drop-down list.

•

GV-RK1352 / R1352 / DFR1352:

Select the

RS-485

checkbox and type the

Serial

Number

of the reader. The ID number located next to the serial number will be assigned

to the reader.

•

GV-Reader 1251 / Reader 1352 V2:

Select the

RS-485

checkbox and leave the serial

number field blank. Note that the ID number located next to the serial number need to
match the reader’s paired ID number defined by the DIP switches on the reader.

•

GV-GF1921 / GF1922 / CR1320:

Type the

MAC address

of the fingerprint reader or the

camera. Don’t select the RS-485 checkbox.

•

GV-CR420:

Select the

RS-485

checkbox only if GV-CR420 is connected to the controller

through RS-485. If the reader is connected through network, do not check the RS-485 box.
Type the

MAC address

of GV-CR420 if using the latest firmware. Refer to the notes

below if you are using firmware V1.0.

Note:

1. The reader supported by each controller differ. For compatible controllers, consult the

reader’s datasheet.

2. When the RS-485 checkbox is not selected, the Extended Reader Configuration page

can be used to configure network readers. However, network readers can also be

quickly and easily set up on GV-ASManager which automatically brings up the readers

MAC address automatically: Controller Setup > General tab > Extender Reader.

Figure 8-25-2