GeoVision GV-AS2120 IP Control Panel - Manual (Page 215)

Optional Devices
213
9
• When
Parking Entry/Exit Control
is selected in the
Function Setting
page (Figure 9-
15), these
Input Type
and
Input Function
become available:
Input Type Input Function Description
Normal Input Enable Latch
Disable Latch See the same Input Type above.
Gate A or B Fire Zone
Tamper Zone
Exit Button
Car Detection See the “Door A or Door B” Input Type
above.
For example, when the
Car Detection
sensor
detects any car driving by, a “Parking Entry”
or “Parking Exit” event occurs and the parking
gate will respond the event accordingly.
• When
Elevator Control
is selected in the
Function Setting
page (Figure 9-15), these
Input Type
and
Input Function
become available:
Input Type Input Function Description
Normal Input Enable Latch
Disable Latch See the same Input Type above.
Relay A or B Fire Zone
Tamper Zone See the “Door A or Door B” Input Type above.
For example, the
Tamper Zone
sensor is
installed on GV-ASBox. So whenever there is
any attempt to open the Box, the “Tamper” event
occurs and it may trigger the “Tamper” alarm.
Note:
For alarm outputs, the corresponding alarms must be enabled (YES) in the
Parameter Setting
page (Figure 9-16). If alarms are set to be disabled (NO), the alarm
function here will not work when triggered.