Enterasys Networks 6000 User Manual
Page 140
Basic Alarm Configuration
4-5
Alarm Configuration
IF Type
Displays each interface’s type: e.g., FDDI, Ethernet, ATM. Note that there is no type
distinction between standard Ethernet and Fast Ethernet.
Status
Displays the current status of the selected alarm type for each interface: Enabled or
Disabled. Remember, this status refers only to the alarm type which is selected at the top
of the window; each of the other two alarm types can have different states.
Log/Trap
Indicates whether or not each alarm has been configured to create a silent log of event
occurrences and the alarms that triggered them, and whether or not each alarm has been
configured to issue a trap in response to a rising or falling alarm condition. Possible values
are log, trap, log&trap, or none.
Polling Interval
Displays the amount of time, in days, hours, minutes, and seconds, over which the selected
alarm variable will be sampled. At the end of the interval, the sample value will be
compared to both the
. You can set any interval
up to 24,855 days.
Rising Threshold
Displays the high threshold value set for the selected alarm variable. Values used to
compare to the thresholds are relative, or delta values (the difference between the value
counted at the end of the current interval and the value counted at the end of the previous
interval); be sure to set your thresholds accordingly.
Rising Action
These option buttons indicate whether or not a rising alarm occurrence will initiate any
actions in response to the alarm condition: Enable Port if bridging will be enabled at the
selected interface in response to a rising alarm, Disable Port if bridging will be disabled at
the selected interface in response to a rising alarm, or None if no actions have been
configured for the selected alarm. Note that the Action fields will be unavailable for
devices configured to operate in SecureFast switching mode, or that do not support the
Actions MIB.
Falling Threshold
Displays the low threshold value set for the selected alarm variable. Values used to
compare to the thresholds are relative, or delta values (the difference between the value
counted at the end of the current interval and the value counted at the end of the previous
interval); be sure to set your thresholds accordingly.
Falling Action
These option buttons indicate whether or not a falling alarm occurrence will initiate any
actions in response to the alarm condition: Enable Port if bridging will be enabled at the
selected interface in response to a falling alarm, Disable Port if bridging will be disabled
in response to a falling alarm, or None if no actions have been configured for the selected
alarm. Note that the Action fields will be unavailable for devices configured to operate in
SecureFast switching mode, or that do not support the Actions MIB.