Enterasys Networks 6000 - Manual (Page 108)

Managing the Module 2-89
The Device View
3. Click the Apply button. The new egress state will be reflected in the VLAN
Port Configuration (Basic) window’s table.
Updating VLAN Port Configuration Information
Clicking the Refresh button will update the information displayed in the Port
Configuration table without closing the window.
Configuring Advanced VLAN Port Parameters
VLAN port configuration including Acceptable Frame Types, Ingress Filtering, and
GVRP status, is performed using the VLAN Port Configuration (Advanced) window,
which is accessed from the VLAN Port Configuration (Basic) window. To launch the
window:
1. In the Device View, select Bridge Extension Configuration... from the Device
menu.
2. In the Bridge Extension Configuration window, click on the VLAN button and
select VLAN Port Configuration... from the menu.
3. At the bottom of the VLAN Port Configuration window, click the Advanced
button. The VLAN Port Configuration (Advanced) window,
Figure 2-31 ,
appears:
NOTE
In order to properly configure the Egress state for backplane ports, the Auto VLAN
Backplane Configuration option should be set to disabled. This option is available via
local management. If the option is set to enabled, the backplane ports cannot be set to No
Egress via Element Manager.