ProSoft Technology 5204SE-MNET-PDPMV1 - Manual (Page 63)

Procedures 5204SE-MNET-PDPMV1 ♦ ProLinx Gateway
User Manual Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master
ProSoft Technology, Inc.
Page 63 of 235
December 22, 2009
3.6.3 Import the M340 Functional Module (.XFM File)
To simplify the task of programming the processor when communicating with the
5204SE-MNET-PDPMV1, the Application Communication Logic functions of
ProSoft Configuration Builder (PCB) create a Unity Pro Functional Module
(XFM).
Note: The Functional Module is intended only for new installations of the gateway. If you have an
existing installation, the following procedure will overwrite your settings, and may cause loss of
functionality. DO NOT overwrite a working application until you have thoroughly reviewed the rest
of the topics in this manual.
The Functional Module provides easy access to:
ƒ PROFIBUS DP-V0 or DP-V1 cyclic input and output data
ƒ gateway input/output status data
ƒ Standard PROFIBUS slave diagnostic data (six bytes per slave)
ƒ PROFIBUS DP-V1 acyclic message data, such as "Get Live List", "Get
(Extended) Slave Diagnostics", perform Freeze and Sync commands, or
perform any slave device-specific commands or functions.
The Functional Module file name matches the gateway name you defined in PCB
and will have the extension ".XFM". This file is created by PCB when you export
the processor file from the Unity Passthru Memory Map box.
To import the Functional Module:
Use the project you created in Unity Pro and perform all of the following steps.
1 Open the V IEW menu, and then choose F UNCTIONAL V IEW .