ProSoft Technology 5204SE-MNET-PDPMV1 - Manual (Page 140)

5204SE-MNET-PDPMV1 ♦ ProLinx Gateway Reference
Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master User Manual
Page 140 of 235
ProSoft Technology, Inc.
December 22, 2009
Hexadecimal Error Codes For TCP/IP Ethernet Network Errors
An error on the TCP/IP Ethernet network itself may produce one of the following
errors in the CONTROL[1] register of the control block.
Hex Error Code Meaning
5004 Interrupted system invocation
5005 I/O error
5006 No such address
5009 The socket descriptor is not valid
500C Not enough storage space
500D Authorization denied
5011 Entry exists
5016 An argument is not valid
5017 An internal table has no more space
5020 There is interference on the connection
5023 This operation was blocked and the socket is non-blocking
5024 The socket is non-blocking and the connection cannot be closed down
5025 The socket is non-blocking and a previous connection attempt has not
been concluded
5026 Socket operation on a non-socket
5027 The destination address is not valid
5028 Message too long
5029 Wrong type of protocol for the socket
502A Protocol not available
502B Protocol not supported
502C Socket type not supported
502D Operation not supported at socket
502E Protocol family not supported
F502 Address family not supported
5030 Address is already in use
5031 Address not available
5032 Network is out of order
5033 Network cannot be reached
5034 Network shut down the connection during reset
5035 The connection was terminated by the peer
5036 The connection was reset by the peer
5037 An internal buffer is required, but cannot be assigned
5038 The socket is already connected
5039 The socket is not connected
503A Cannot transmit after the socket has been shut off
503B Too many references; cannot splice
503C Connection timed out
503D The connection attempt was denied
5040 Host is out of order
5041 The destination host could not be reached from this node
5042 Directory not empty
5046 NI_INIT returned -1
5047 The MTU is not valid