ProSoft Technology 5204SE-MNET-PDPMV1 - Manual (Page 219)

Reference 5204SE-MNET-PDPMV1 ♦ ProLinx Gateway
User Manual Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master
ProSoft Technology, Inc.
Page 219 of 235
December 22, 2009
4.7.2 Return Codes
Possible error codes in Message Data word "Return Code" (The Return Codes
can be byte swapped)
Return Code Name Meaning
8010h DPMC_ERR_V1C_CLOSED Internal DPMC instance no longer exists.
8011h DPMC_ERR_V1C_STOPPED Internal DPMC instance has already been stopped
8012h DPMC_ERR_V1C_STARTED Internal DPMC instance has already been started
8013h DPMC_ERR_V1C_STATE_UNKNOWN Internal DPMC instance has entered an undefined
state
8021h DPMC_ERR_V1C_REQ_ACTIVE A request is already active
8022h DPMC_ERR_V1C_NOT_ALLOWED Internal DPMC module not initialized correctly
8023h DPMC_ERR_V1C_INVALID_PAR Invalid parameter in user request
8024h DPMC_ERR_V1C_MEM_ALLOC Internal memory allocation error
8025h DPMC_ERR_V1C_L2_REQ Unknown opcode in the confirmation
8026h DPMC_ERR_V1C_TIMEOUT Active request terminated with timeout
8028h DPMC_ERR_V1C_INVALID_LEN Invalid length in user request
8030h DPMC_ERR_V1C_REQ_NEG 1 Negative indication from lower layer
8031h DPMC_ERR_V1C_REQ_RE Message frame format error in response
8042h DPMC_ERR_V1C_REQ_WITHDRAW Request was recalled
8043h DPMC_ERR_V1C_REQ_NOT_FOUND Associated request block not found
80C1h DPMC_ERR_V1C_MM_FE Format error in request frame
80C2h DPMC_ERR_V1C_MM_NI Function not implemented
80C3h DPMC_ERR_V1C_MM_AD Access denied
80C4h DPMC_ERR_V1C_MM_EA Area too large
80C5h DPMC_ERR_V1C_MM_LE Data block length too large
80C6h DPMC_ERR_V1C_MM_RE Format error in response frame
80C7h DPMC_ERR_V1C_MM_IP Invalid parameter
80C8h DPMC_ERR_V1C_MM_SC Sequence conflict
80C9h DPMC_ERR_V1C_MM_SE Sequence error
80CAh DPMC_ERR_V1C_MM_NE Area non-existent
80CBh DPMC_ERR_V1C_MM_DI Data incomplete or incorrect
80CCh DPMC_ERR_V1C_MM_NC Master parameter set not compatible
4.7.3 Error Codes
If return code indicates DPMC_ERR_V1C_REQ_NEG, the status values
according to the DP-standard may be available in Error Code 1. Refer to the
PROFIBUS DP specification for information on how to interpret these status
values.
Error Code Name Meaning
01h L2_STATUS_UE
02h L2_STATUS_RR
03h L2_STATUS_RS
0Ch L2_STATUS_RDL Refer to PROFIBUS DP specification
0Dh L2_STATUS_RDH
0Fh L2_STATUS_NA