ProSoft Technology 5204-DFNT-PDPMV1 - Manual (Page 81)

PDPMV1 ♦ ProLinx Gateway Mailbox Messaging
PROFIBUS DPV1 Master Protocol Manual
ProSoft Technology, Inc. Page 81 of 157
March 23, 2011
Command and Response Layout: Set Slave Mode
Command Response
Message ID (ID) (ID)
Acyclic Message Status
Word
4002h 0002h
Command 0003h 0003h Set Slave Mode
Data size 0000h 0000h
Frame count 0001h 0001h
Frame number 0001h 0001h
Offset high 0000h 0000h
Offset low 0000h 0000h
Extended word 1 Slave
Address
Group Select Slave
Address
Group Select
Extended word 2 Control
Command
Control
Command
Extended word 3 - -
Extended word 4 - -
Extended word 5 - -
Extended word 6 - -
Extended word 7 - Extended Fault Information
Extended word 8 Fault Information
Acyclic Message Status Word
Refer to Acyclic Message Status Word (page 99).
Slave Address
Range 1 to 125; 127
If the request applies for only one slave, that Slave Address must be entered in
the range 1 to 125. If a slave group is to be addressed, Slave Address should be
127 (Multicast address).