ProSoft Technology 5204-DFNT-PDPMV1 - Manual (Page 49)

PDPMV1 ♦ ProLinx Gateway Configuration
PROFIBUS DPV1 Master Protocol Manual
ProSoft Technology, Inc. Page 49 of 157
March 23, 2011
2.4.4 Other Mailbox Commands
3 - Set Slave Mode
Field Value Description
Type 0 to 3
DB_Reg Database location for the three values used by the
command.
Count If count == 0, the three values for the command are derived
from the database. If count != 0, the three parameters for the
command are present in the command list.
Poll_Int Only if type = 1
Swap Not used
DB_Trigger
Func 3
Param_1 0 to 125 or 127 This field represents the slave address for the command.
Address 127 is used for multicast address.
Param_2 Group Select Refer to Mailbox Message: Set Slave Mode (page 80)
Param_3 Control Command Refer to Mailbox Message: Set Slave Mode (page 80)
4 - Get Slave Diagnostic Data
Field Value Description
Type 0, 1 or 3
DB_Reg This is the database location where the results of the
command will be placed
Count This parameter specifies the number of words in the
response message to place in the database.
Poll_Int Only if type = 1
Swap Utilized on response message
DB_Trigger
Func 4
Param_1 0 to 125 This field represents the slave address for the command.
Param_2 Type of Req If 0, internal database used. If 1, data polled on network.
This last option is used if the slave is not controlled by this
Master.