ProSoft Technology 5204-DFNT-PDPMV1 - Manual (Page 50)

Configuration PDPMV1 ♦ ProLinx Gateway
Protocol Manual PROFIBUS DPV1 Master
Page 50 of 157 ProSoft Technology, Inc.
March 23, 2011
5 - Get Slave Configuration
Field Value Description
Type 0, 1 or 3
DB_Reg This is the database location where the results of the
command will be placed
Count This parameter specifies the number of words in the
response message to place in the database.
Poll_Int Only if type = 1
Swap Utilized on response message
DB_Trigger
Func 5
Param_1 1 to 125 This field represents the slave address for the command.
23 - Get Database Information
Field Value Description
Type 0, 1 or 3
DB_Reg Location of the 4 words received in the response to this
request.
Count This field is not used as the message is always 4-words in
length
Poll_Int Only if type = 1
Swap Utilized on response message
DB_Trigger
Func 23
32 - Acyclic Read
Field Value Description
Type 0, 1 or 3
DB_Reg Database location where read data placed
Count Number of words in response message to write to the
database.
Poll_Int Only if type = 1
Swap Applied to data in response message
DB_Trigger
Func 32
Param_1 Slave Addr Slave address to read data from
Param_2 Slot Slot in slave to access
Param_3 Index Index in slave to access
Param_4 Len Length in bytes of data to be sent from the slave.