ProSoft Technology 5204-DFNT-PDPMV1 - Manual (Page 128)

Reference PDPMV1 ♦ ProLinx Gateway
Protocol Manual PROFIBUS DPV1 Master
Page 128 of 157 ProSoft Technology, Inc.
March 23, 2011
5.1.5 Quick Start
The following steps demonstrate how to start the FDT (Field Device Tool)
program and configure the PROFIBUS comDTM.
Starting FDT
1 Start the FDT program and login as administrator. The following procedures
use PACTware 3.0 software.
2 Click the U PDATE DEVICE CATALOG button. If PROFIBUS comDTM was
installed successfully, it will appear in the Device Catalog window.
3 Select the P RO S OFT T ECHNOLOGY COM DTM entry in the device catalog, and
then click A DD .
4 Repeat steps 1 through 3 to add any other manufacturer’s device DTMs
installed on your computer. Select the correct address for each device, and
then click OK to proceed.
Note: You must use the same PROFIBUS device address that you used when setting up the
device.