ProSoft Technology MVI71-DNP - Manual (Page 50)

MVI71-DNP ♦ PLC Platform Installing and Configuring the Module
DNP 3.0 Master/Slave Communication Module
Page 50 of 172 ProSoft Technology, Inc.
August 23, 2007
2.3 Uploading and Downloading the Configuration File
ProSoft modules are shipped with a pre-loaded configuration file. In order to edit
this file, you must transfer the file from the module to your PC. After editing, you
must transfer the file back to the module.
This section describes these procedures.
Important: The illustrations of configuration/debug menus in this section are intended
as a general guide, and may not exactly match the configuration/debug menus in your
own module. For specific information about the configuration/debug menus in your
module, refer to The Configuration/Debug Menu.
2.3.1 Transferring the Configuration File to Your PC
1 Connect your PC to the Configuration/Debug port of the module using a
terminal program such as HyperTerminal. Press [?] to display the main
menu.
2
Press [>] key (Send Module Configuration). The message "Press Y to
confirm configuration send!" is displayed at the bottom of the screen.