ProSoft Technology MVI71-DNP - Manual (Page 131)

Reference MVI71-DNP ♦ PLC Platform
DNP 3.0 Master/Slave Communication Module
ProSoft Technology, Inc. Page 131 of 172
August 23, 2007
[Section]/Item Value Range Description
Binary Outputs: 0 to 15360
points Number of binary output points contained in
the IED database which are transferred from
the PLC processor and used by the attached
IED units.
Analog Outputs: 0 to 960 pointsNumber of analog output points contained in
the IED database which are transferred from
the PLC processor and used by the attached
IED units.
[Section]/Item Description
[DNP Master Slave List] Definition of the IED units to be interfaced
with the DNP master port if utilized
# This section stores information about each slave to be used by the master port. There must be an
# entry in this table for each node to be used in the command list. Two of the parameters in this list
are coded
# values:
# Conf Mode ==> 0=Never, 1=Sometimes and 2=Always (select 0).
# Flags is bit coded as
follows:
# Bit 0 (decimal 1) ==> Enable the
slave
# Bit 1 (decimal 2) ==> Use Unsolicited messaging with this slave
# Bit 2 (decimal 4) ==> Use delay measurement with this slave
# Bit 3 (decimal 8) ==> Auto time synchronization
enabled
#
# Node DL Conf Conf Conf App Rsp
# Address Mode Timeout Retry Timeout Flags
START
END
[Section]/Item Description
[DNP Master Commands] Definition of the commands to be issued to
the IED units by the DNP master port.
# This section contains the list of commands to process on the master port.
# Node addresses present in the command list must have an entry in the
# [DNP Slave List]. Commands with nodes not present in the list will not be
# executed.
# 1 2 3 4 5 6 7 8 9 10
#Flags/ Node Data Data Cmd Device Point DNP DB IED DB Poll
#Enable Address Object Variation Func Address Count Address Address interval
START
END