ProSoft Technology MVI71-DNP - Manual (Page 128)

MVI71-DNP ♦ PLC Platform Reference
DNP 3.0 Master/Slave Communication Module
Page 128 of 172 ProSoft Technology, Inc.
August 23, 2007
[Section]/Item Value Range Description
Float Inputs: 0 to 240 pointsNumber of floating-point input points to
configure in the DNP slave device. Each point
will occupy a two-word area in the module
memory.
PLC Float Inputs: 0 to 240 pointsNumber of floating-point input points
configured above that are to be obtained from
the PLC.
Counters: 0 to 480 pointsNumber of counter points to configure in the
DNP slave device. Each point will occupy a
two word area in the module memory. This
number corresponds to the number of frozen
counters. The application maps the counters
to the frozen counters directly.
PLC Counters: 0 to 480 pointsNumber of counter points configured above
that are to be obtained from the PLC
processor. All other counter points must come
from the attached IED units.
Binary Outputs: 0 to 15360
points Number of digital output points to configure in
the DNP slave device. Each point will be
stored as a single bit in the module memory.
PLC Binary Outputs: 0 to 15360
points Number of digital output points configured
above that are to be sent to the PLC
processor. All other binary output points will
be sent to the attached IED units.
Analog Outputs: 0 to 960 pointsNumber of analog output points to configure
in the DNP slave device. Each point will
occupy a one word area in the module
memory.
PLC Analog Outputs: 0 to 960 pointsNumber of analog output points configured
above that are to be sent to the PLC
processor. All other analog output points will
be sent to the attached IED units.
Float Outputs: 0 to 240 pointsNumber of floating-point output points to
configure in the DNP slave device. Each point
will occupy a two- word area in the module
memory.
PLC Float Outputs: 0 to 240 pointsNumber of floating-point output points
configured above that are to be sent to the
PLC.
[Section]/Item Description
[DNP Slave Binary Inputs] DNP database binary input override values
# This area is to override the class assignment for binary input database points. Enter list of points
between the
# START and END labels.
#
# Point# Class
START
END