ProSoft Technology MVI71-DNP User Manual
Page 14
MVI71-DNP ♦ PLC Platform
Start Here
DNP 3.0 Master/Slave Communication Module
Page 14 of 172
ProSoft Technology, Inc.
August 23, 2007
Warning: This module is not hot-swappable!
Always remove power from the rack
before inserting or removing this module, or damage may result to the module, the
processor, or other connected devices.
1
Turn power OFF.
2
Align the module with the top and bottom guides, and slide it into the rack
until the module is firmly against the backplane connector.
3
With a firm but steady push, snap the module into place.
4
Check that the holding clips on the top and bottom of the module are securely
in the locking holes of the rack.
5
Make a note of the slot location. You will need to identify the slot in which the
module is installed in order for the sample program to work correctly. Slot
numbers are identified on the green circuit board (backplane) of the PLC
rack.
6
Turn power ON.
Note:
If you insert the module improperly, the system may stop working, or may
behave unpredictably.