Analog outputs (60 points/block) – ProSoft Technology MVI71-DNP User Manual
Page 120
MVI71-DNP ♦ PLC Platform
Reference
DNP 3.0 Master/Slave Communication Module
Page 120 of 172
ProSoft Technology, Inc.
August 23, 2007
Analog Outputs (60 points/block)
Block #
PLC File #
Start
End
Points
80
N
1 to
60
81
N
61 to
120
82
N
121 to
180
83
N
181 to
240
84
N
241 to
300
85
N
301 to
360
86
N
361 to
420
87
N
421 to
480
88
N
481 to
540
89
N
541 to
600
90
N
601 to
660
91
N
661 to
720
92
N
721 to
780
93
N
781 to
840
94
N
841 to
900
95
N
901 to
960
Fill in this form for the application being developed. The data areas in the PLC for
the different data types (defined by the start and end values for a PLC file) should
not overlap. If they do, unpredictable results may occur. For example, do not
define the same address range of N10:0 to 59 for both digital inputs and outputs.
The difference between the end and start addresses in the PLC files should not
exceed 60 words. For example 0 to 60 is invalid. Whereas, 0 to 59 is valid.
Note that the number of points represented in each block is denoted. Also shown
is the point range for the points defined for the block if the maximum 60 words
are defined.