PLANET WGSW-48040HP - Manual (Page 97)

Command Guide of WGSW-48040HP
Command:
lldp transmit
lldp LLDP configurations
transmit Enable/Disabled transmision of LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Tx only mode for specific interface
Example:
To configure LLDP Tx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp transmit
4.2.45.55 loop-protect
Command:
loop-protect
loop-protect Loop protection configuration
Default:
Enabled
Usage Guide:
To enable loop-protect for specific interface
Example:
To enable loop-protect for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect
4.2.45.56 loop-protect action
Command:
-97-